The cased axial Miniflow SAMF is a duct mounted axial fan with a lightweight, yet robust design. Specifically developed as a cost effective alternative to in-line centrifugal fans, it provides powerful airflow at lower pressures for applications ranging from domestic to commercial ventilation.
- 4 standard sizes from 150mm to 315mm.
- Air volume flow rates up to 0.55 m³/s.
- Static pressures up to 150 Pa.
- Suitable for operating temperatures up to +50°C.
- Available in AC.
FEATURES & BENEFITS
Learn more about individual features and benefits of our products.
The Miniflow SAMF range of axial fans as manufactured by Elta Fans Ltd.
The technical information available to you from ELTA Fans is exhaustive - Choose from either sound, performance and electrical or dimensional data for each and every product
Elta supply a full range of accessories for each of their products.
Choose up to three products to compare their features side-by-side.
Get the full brochure, wiring diagrams and operation and maintenance instructions.
Features & Benefits
Casings provide a long lasting construction, manufactured from galvanised steel, with a high quality powder coated finish after manufacture on all models except the SAMF150/2-2 which has a die cast aluminium housing.
Ease of installation.
Lightweight design of the SAMF ensures a swift, easy to install product, whilst spigot inlet & outlet connections allow ease of installation for ductwork system fitting. A pre-wired terminal box is also fitted which is external to the casing.
All motors are fitted with integral ‘Thermal overload protection’ preventing the motor from overheating, except the SAMF 150/2-2 which is impedance protected.
External rotor motor
These are high quality motors and maintenance free with sealed for life ball bearings, which means the fan can be mounted at any angle.
These are aerodynamically designed by combining the impeller with the rotor of the external rotor motor. The motor and impeller is balanced to quality class G6.3.
Each fan is fully speed controllable with an electronic controller, which means airflow can be altered to suit site conditions.
All units are designed and manufactured with procedures as defined in BS EN ISO 9001: 2008
The Miniflow SAMF as manufactured by Elta Fans Ltd. 46 Third Avenue, Pensnett Trading Estate, Kingswinford, West Midlands, DY6 7US, UK. Tel: +44 (0) 1384 275800 - If you need more information - Contact us.
The all metal fan casing provides a long lasting and robust construction. The units have been constructed from mild steel, with mounting brackets as an integral component. Both motors and axial impellers mounted within the length of the unit casing. All casing parts shall have a powder coated finish after manufacture, except the SAMF150/2-2 which has a die cast aluminium housing.
External rotor motor, with sealed for life ball bearings, allowing the unit to be mounted at any angle. Motors shall be IP44 protected and Class ‘B’ insulation. All units are suitable for a maximum of 80% R.H. and ambient operating temperatures up to +50°C. Motors are wound for 220V to 240V/1Ph/50Hz AC supply, with built in thermal overload protection, except the SAMF150/2-2 which is impedance protected.
The impeller is aerodynamically designed by combining the impeller with the rotor of the external rotor motor. Motor and impeller are balanced to ISO 14694 Grade G6.3.
Units are to be designed and manufactured with procedures as defined in BS EN ISO 9001:2008. All SAMF units are to be tested to ISO 5801:2007 (airside performance) and BS 848 Part 2:1985 (sound performance).
- Small commercial premises
- Kitchens (where there is not an outside wall to terminate a wall fan)
Mounting Brackets (SAMF)
Bracket to match fanRead more
Accessories & Wiring Data